MATX/E-Machine Power Supply. UL approved 115/230V switchable power supply. 2 1/2" x 5" x 4". Product Features: High efficiency. Low Ripple & Noise. Output over voltage protection. Short circuit protection on all output. Resettabel power shut down. Approved by UL, TUV, IEC, CB & CE. Internal 12 VDE fan provided. 100% burn-in under high ambient temperature (50C). Vacuum-impregnated transformer . MTBF: 100K HOURS AT 25C. 100% Hi-pot tested. Line input fuse protection. Passive PFC (Power Factor Correction) Circuit at 230Vac. Product Specifications: Atx / P4 12v read, 200W, 4 12v connector, UL CE&C. Over voltage protection: +5V output: 6.5V, +3.3V output: 4. Overload protection: 150% Max. Power good signal: turn-on delay 100ms to 500ms. AC INPUT: 115/230 Vac ~ 8/4A 60/50Hz. DC OUTPUT: $Voltage: +3.3V, Min. Current: 11.5A, Max. Current: 18.7A $Voltage: +5V, Min. Current: 12.6A, Max. Current: 16A $Voltage: -5V, Output: 0.3A $Voltage: +12V, Output: 10A $Voltage: -12V, Output: 0.3A $Voltage: +5V-SB, Output: 2.0A. Remote ON/OFF control: The power shall accept a logic collector level which will disable / enable all putput voltage (excluding +5V standby)
Temperature Range: Operating 0C-50C: Non-operating: -20C-+65C. Temperature coefficient: 0.01%C. Transient Response: Output voltage recovers in less than 1 ms max. following a 25% load change. Hold up time: 10.0ms minimum at 230V/50Hz. dielectric withstand: Input/output 1800VAC for 1 second, input to frame ground 1800 VAC for 1 second. Humidity: 5-95% RH. Efficiency: 60% Min, 70% typical at full load. Power good signal: turn-on delay 100ms to 500ms Overload protection: 150% Max.
